West Coast Connection Forum

Elements => Tha Studio => Topic started by: J Bananas on September 07, 2006, 01:30:15 AM

Title: new beat, tell me what u think
Post by: J Bananas on September 07, 2006, 01:30:15 AM
"clockwork", pretty quick to do

http://www.zshare.net/audio/clockwork-mp3.html (http://www.zshare.net/audio/clockwork-mp3.html)
Title: Re: new beat, tell me what u think
Post by: Cheese on September 07, 2006, 02:13:42 AM
It's nice, but i would make the bussdrums more banging right from the start
Title: Re: new beat, tell me what u think
Post by: MontrealCity's Most on September 07, 2006, 07:25:08 AM
Very nice melody, i would make the snair more snappy/ more crisp but thats about it very nice melody
Title: Re: new beat, tell me what u think
Post by: J Bananas on September 07, 2006, 12:48:03 PM
oh man i was so high when i did this last night the melody doesn't even sync up properly. i do remember i had to subtract some of the lower frequencies tho cuz the bass drums were fuckin up my speakers, so i dont know theyre gonna bang harder without sounding like shit :-\  and thanks for the advice about the snares i'll pull a j dilla and layer a couple different ones together
Title: Re: new beat, tell me what u think
Post by: Mr. O on September 07, 2006, 01:32:49 PM
oh man i was so high when i did this last night the melody doesn't even sync up properly. i do remember i had to subtract some of the lower frequencies tho cuz the bass drums were fuckin up my speakers, so i dont know theyre gonna bang harder without sounding like shit :-\  and thanks for the advice about the snares i'll pull a j dilla and layer a couple different ones together
Don't be fool by the sound..if they sound very loud from ya amp, it should because when u convert into cd..the quality will reduce...

check your master meter and make it doesn't peak..but remains somewhere at 0.5 to 2.0
Title: Re: new beat, tell me what u think
Post by: J Bananas on September 07, 2006, 02:49:33 PM
ok for sure, thanks
Title: Re: new beat, tell me what u think
Post by: Mr. O on September 07, 2006, 03:33:48 PM
ok for sure, thanks
i meant...master control is zero..set to zero..

but when you see the bars moving up and down...make sure it peaks up to -1.5 (depending how your program is set up). do not peak beyond zero.